Kango

The Kango range stocked here is a short, practical selection of trade tools rather than a full catalogue. It covers application tools, specifically a taping knife and a bucket scoop, along with K4 SDS Plus drill bits. Every item sits under Application Tools, and the drill bits are also grouped with Crack Repair and Injection Systems because that is where they get used most.

They are made for percussive drilling into concrete, brick and masonry using a rotary hammer. On waterproofing and remedial jobs they are typically used to drill the port holes for crack injection, and they also suit general anchor and fixing holes. Check the individual product listings to match the bit to the port or anchor you are working with.

SDS Plus is a standardised shank system, so these bits fit any rotary hammer with an SDS Plus chuck regardless of which brand made the tool. They are not designed for a standard keyed or keyless drill chuck, and forcing them into one will not deliver the hammer action the bit relies on. If your hammer takes an SDS Max shank, these will not fit.

They are two different shank systems and they are not interchangeable. SDS Plus is the lighter of the two and is what most waterproofers and remedial trades run for injection ports, anchor holes and general fixing work. The Kango bits in this range are SDS Plus, so check the chuck on your hammer before ordering.

It is a broad bladed hand tool for spreading and working bedding compounds, patching mixes and fillers across a flat area. Waterproofers use it to press material into corners and around penetrations, then feather the edge back flush before the next coat goes on. It is a general application tool rather than a product specific applicator, so it suits most knife or trowel applied materials.

The Kango bucket scoop is for decanting powder and granular product out of a bag and into a mixing bucket without spilling it down the side. It makes batching far more consistent when you are mixing cementitious products in part batches, which matters because an off ratio mix will not perform the way it should. Always follow the mix ratio given on the product's technical data sheet rather than judging it by eye.

The Kango items we carry, being the taping knife, the bucket scoop and the K4 SDS Plus drill bits, are stocked on this collection page and ship anywhere in Australia. Because this is a short accessory range rather than a full tool line, most customers add the drill bits to a crack injection order so the bits and the resin turn up together. If the diameter you need is not showing, call the team and we can check what is available.