Pool System Build-Up
- 1 Concrete Substrate
- 2 Crack Repair (if required)
- 3 ACTFLEX FLEXPLUS
- 4 ACTFLEX HYDROPLUG
- 5 ACTFLEX AT MESH
- 6 ACTFLEX 988 CWP (2 Coats)
- 7 Tile Adhesive
- 8 Pool Finish
Flood Test Balloon
$19.00
ACTFLEX 400 CLEAR Over-Tile Leak Repair Coating
$45.00
Innovative Tools 230mm FC Sheeting Puddle Flange Recess Kit
$341.00
Soudal T-Rex Crystal
$13.00
Puddle Pro 90mm Puddle Flange
$11.00
Puddle Pro 100mm Puddle Flange
$11.00
BAT Spike Roller 21mm x 500mm
$38.00
STAIN-PROOF Premium Impregnating Sealer by Dry-Treat
$54.00

SWM crack injection hose. Blue coil with a crimped hex fitting on each end.
The SWM Crack Injection Hose is a single blue coil with a crimped metal hex fitting on each end. Both fittings are zinc plated.
Specs
One coil, crimped hex fitting on each end. Call us to confirm the length, bore and thread suit your pump before you buy.
Pickup available at The Waterproofing Shop
Usually ready in 24 hours

SWM Crack Injection Hose
The Waterproofing Shop
22/872 Canterbury Road
Roselands NSW 2196
Australia
No documentation available for this product.

Correct application makes all the difference.
| Item Type | Crack injection hose |
| Supplied As | A single coil of about eight turns |
| Cover | Blue and smooth, with fine longitudinal ribbing in the surface |
| End Fittings | A crimped metal end fitting on each end |
| Fitting Form | Hex nut over a crimped ferrule |
| Fitting Finish | Zinc plated with a yellow passivated finish |
| Markings | No lay line, branding or marking legible on the cover or on either fitting |
| Every line above is read off the product photograph. No manufacturer data sheet is published for this hose, so the coil length, the internal bore, the fitting thread size and the working pressure rating are not stated. | |
Before
After
Gold Coast, QLD
Before
After
Sydney, NSW
Before
After
Perth, WA
Before
After
Melbourne, VIC
Brisbane, QLD
Step-by-step from prep to top coat. Filmed on the tools, not in a studio.

We supply premium waterproofing products backed by expert advice, fast service and real-world experience.
The SWM Crack Injection Hose is the primary high-pressure hose connecting the INJEXA SWM 1300/1500 pump to the injection handle, rated for the full operating pressure range of the system.
Standard hydraulic hoses cannot tolerate the chemical attack of polyurethane and epoxy injection resins. The SWM hose has a chemically resistant inner liner rated for PU200, PU500, Injectswell, ER300, and other Forspec injection products.
Threads onto the pump outlet at one end and the Injection Handle SWM at the other. Hand-tighten the fittings then snug with a wrench - do not overtighten the threads.
Designed for INJEXA SWM 1300 and SWM 1500 pumps. Other pump systems use different fittings - verify before ordering replacements.
Replace immediately if you see swelling, blistering, abrasion, or fluid weeping at the fittings. A failed high-pressure hose is a serious safety hazard - never use a damaged hose.